Get a suggested wrap-label width and height from container diameter or circumference, height, gap and margins.

Loading tool…

This tool provides automated labeling assistance and general information. Requirements vary by product, formulation, market and regulatory status. Verify your final label against current applicable regulations and obtain professional regulatory advice where appropriate before commercial use.

Measuring the container

Measure the diameter, or wrap a paper strip around the container to get the circumference. Then measure the usable height: the straight, flat section between the shoulder and the heel where a label sits flat. Labels applied over curves wrinkle or lift.

Formulas

  • circumference = π × diameter
  • full-wrap width = circumference + overlap. Partial-wrap width = circumference − uncovered gap
  • label height = usable height − top margin − bottom margin

Example: a 60 mm diameter bottle has a circumference of 188.5 mm. A full wrap with a 6 mm overlap is 194.5 mm wide. With 70 mm of usable height and 3 mm margins, the label is 64 mm tall.

Panels and the facts panel

Set the share of the label reserved for the back panel (Supplement Facts, other ingredients, directions and warnings). The calculator shows that zone’s width and the label area in square inches. US type-size allowances for small packages depend on the space available for labeling, which the generator’s package-size setting uses.

Labels for tapered containers need a curved (cone) die line that this calculator does not produce. Always check a printed sample on the actual container, and ask your label printer about their tolerances. Send the size to the label maker to start a design with panel guides.